C8.3 Industrial Troubleshooting Symptoms Charts Section TS - Troubleshooting Symptoms Page TS-9 Alternator Not Charging or Insufficient Charging Cause Correction STEP 1 Alternator pulley is loose on the shaft ............. Tighten the pulley. Refer to OEM service manual. OK Go To Next Step Check the condition of the batteries. Replace the batteries, if necessary. Refer to Procedure 013-007 (Batteries) in Section 4 . STEP 2 Batteries have malfunctioned ............. OK Go To Next Step STEP 3 Battery cables or connections are loose, broken, or ............. Check the battery cables and connections.
corroded (excessive resistance) OK Go To Next Step STEP 4 Alternator is overloaded, or alternator capacity is ............. Install an alternator with a higher capacity. Refer to the OEM service manual. below specification OK Go To Next Step Test the alternator output. Replace the alternator or voltage regulator if necessary. Refer to the OEM service manual. STEP 5 Alternator or voltage regulator is malfunctioning ............. OK Go To Next Step STEP 6 Battery temperature is above specification ............. Position the batteries away from heat sources. Refer to the OEM service manual.
OK Go To Next Step STEP 7 Electrical system is "open" (blown fuses, broken Check the fuses, wires, and connections. Refer to the OEM service manual and the manufacturer's wiring diagram. wires, or loose connections) ............. OK Go To Next Step STEP 8 Vehicle gauge is malfunctioning ............. Check the vehicle gauge. Refer to the OEM service manual. OK Go To Next Step STEP 9 Contact a Cummins® Authorized Repair Facility