Cummins — 4021330

Troubleshooting Symptoms Charts C8.3 Industrial Page TS-20 Section TS - Troubleshooting Symptoms Engine Difficult to Start or Will Not Start (Exhaust Smoke) Cause Correction STEP 1 Starting procedure is not correct ............. Verify the correct starting procedure. Refer to Procedure 101-014 (Normal Starting Procedure) in Section 1. OK Go To Next Step STEP 2 Fuel level is low in the tank ............. Fill the supply tank. Refer to the OEM service manual. OK Go To Next Step STEP 3 Starting aid, if necessary for cold weather, is Check for correct operation of the cold weather starting aid. Refer to Procedure 101-004 (Cold Weather Starting) in Section 1. malfunctioning .............

OK Go To Next Step STEP 4 Engine block heater is malfunctioning (if equipped) ............. Check the electrical sources and wiring to the cylinder block heater. Replace the block heater, if necessary. Refer to the OEM service manual. OK Go To Next Step STEP 5 Fuel heater is malfunctioning (if equipped) ............. Check the fuel heater and replace, if necessary. Refer to the manufacturer's instructions. OK Go To Next Step STEP 6 Battery voltage is low ............. Check the batteries and the unswitched battery supply circuit. Refer to Procedure 013-007 (Batteries) in Section 4. OK Go To Next Step STEP 7 Keyswitch circuit is malfunctioning .............

Check the vehicle, equipment, or vessel keyswitch circuit. Refer to the OEM service manual. OK Go To Next Step If the cranking speed is slower than 150 rpm, refer to the Engine Will Not Crank or Cranks Slowly symptom tree. STEP 8 Engine cranking speed is too slow ............. OK Go To Next Step Check the vehicle brakes for dragging, transmission malfunction, cooling fan operation cycle time, and engine-driven units. Refer to the OEM service manual. STEP 9 Vehicle parasitics are excessive ............. OK Go To Next Step