Troubleshooting Symptoms Charts C8.3 Industrial Page TS-22 Section TS - Troubleshooting Symptoms Engine Difficult to Start or Will Not Start (No Exhaust Smoke) Cause Correction STEP 1 Starting procedure is not correct ............. Verify the correct starting procedure. Refer to Procedure 101-014 (Normal Starting Procedure) in Section 1. OK Go To Next Step STEP 2 Fuel level is low in the tank ............. Fill the supply tank. Refer to the OEM service manual. OK Go To Next Step Check for loose wires and verify that the fuel shutoff valve is functioning. Check to be sure manual shutoff lever is in the run position. Refer to the OEM service manual.
STEP 3 Fuel shutoff valve is malfunctioning ............. OK Go To Next Step Isolate the OEM engine protection system. Follow the OEM service manuals to check for a malfunction. STEP 4 OEM engine protection system is malfunctioning ............. OK Go To Next Step STEP 5 Battery voltage is low ............. Check the batteries and the unswitched battery supply circuit. Refer to the OEM service manual . OK Go To Next Step STEP 6 Keyswitch circuit is malfunctioning ............. Check the vehicle, equipment, or vessel keyswitch circuit. Refer to the OEM service manual. OK Go To Next Step Check for air in the fuel system.
Tighten or replace the fuel connections, fuel lines, fuel tank standpipe and fuel filters as necessary. Vent air from the system. Refer to Procedure 006-003 (Air in Fuel) in Section A. STEP 7 Air in the fuel system ............. OK Go To Next Step STEP 8 Fuel transfer pump malfunctioning ............. Inspect the fuel transfer pump. Replace if necessary. Refer to the OEM service manual. OK Go To Next Step STEP 9 Fuel drain backup ............. Verify the fuel return line is plumbed to the bottom of the fuel tank. OK Go To Next Step