Cummins — 4021330

C8.3 Industrial Troubleshooting Symptoms Charts Section TS - Troubleshooting Symptoms Page TS-41 Engine Will Not Reach Rated Speed (RPM) Cause Correction STEP 1 Vehicle speed is too low for adequate cooling with ............. Reduce the engine load. Increase the engine (fan) rpm by downshifting. high engine load OK Go To Next Step STEP 2 Throttle linkage adjustment is not correct ............. Check throttle linkage adjustment. Refer to the OEM service manual. OK Go To Next Step Compare the tachometer reading with a handheld tachometer or an electronic service tool reading. Calibrate or replace the tachometer as necessary. Refer to the OEM service manual.

STEP 3 Tachometer is not calibrated or is malfunctioning ............. OK Go To Next Step STEP 4 Air-fuel tube leaking, wastegate diaphragm Tighten the fittings, repair plumbing, replace wastegate diaphragm. Refer to the OEM service manual or an Authorized Cummins Repair Facility. ruptured, or wastegate plumbing damaged ............. OK Go To Next Step STEP 5 Charge air cooler restricted (if equipped) ............. Inspect the air cooler for internal and external restrictions. Replace the restricted cooler if necessary. Refer to the OEM service manual. OK Go To Next Step STEP 6 Fuel supply is not adequate .............

Check the flow through the filter to locate the source of the restriction. Refer to the OEM service manual. OK Go To Next Step Make sure fuel shutoff lever is in the RUN position. Replace if necessary. Refer to the OEM service manual. STEP 7 Fuel shutoff lever (mechanical) partially engaged ............. OK Go To Next Step STEP 8 Exhaust back pressure too high ............. Measure and correct if above specification. Refer to an Authorized Cummins Repair Facility. OK Go To Next Step STEP 9 Fuel transfer pump malfunctioning ............. Inspect the fuel transfer pump. Replace if necessary. Refer to the OEM service manual. OK Go To Next Step