C8.3 Industrial Troubleshooting Symptoms Charts Section TS - Troubleshooting Symptoms Page TS-47 Fuel Consumption Excessive Cause Correction STEP 1 Operator technique is not correct ............. Refer to Procedure 101-015 (Normal Operating Procedure) in Section 1. OK Go To Next Step Check the fuel lines, fuel connections, and fuel filters for leaks. Check the fuel lines to the supply tanks. Refer to the OEM service manual. STEP 2 Fuel leak ............. OK Go To Next Step Check the hubometer and odometer calibrations. Calibrate or replace the hubometer or odometer, if necessary. Calculate fuel consumption with new mileage figures. STEP 3 Hubometer or odometer is miscalibrated .............
OK Go To Next Step Check for loose or damaged piping connections and missing pipe plugs. Check the turbocharger and exhaust manifold mounting. Refer to the OEM service manual. STEP 4 Air intake or exhaust leaks ............. OK Go To Next Step STEP 5 Air intake or exhaust leaks ............. Inspect the air intake and exhaust systems for air leaks. Refer to the OEM service manual. OK Go To Next Step STEP 6 Air intake system restriction is above specification ............. Check the air intake system for restriction. Clean or replace the air filter and inlet piping as necessary. Refer to Procedure 010-058 (Air Intake Piping) in Section 6.
OK Go To Next Step STEP 7 Equipment and environmental factors are affecting Consider ambient temperatures, wind, tire size, axle alignment, routes, and use of aerodynamic aids when evaluating fuel consumption. fuel consumption ............. OK Go To Next Step STEP 8 Lubricating oil level is above specification ............. Check the oil level. Verify the dipstick calibration and oil pan capacity. Fill the system to the specified level. Refer to Procedure 007-043 (Lubricating Oil Level) in Section 3. OK Go To Next Step STEP 9 Contact a Cummins® Authorized Repair Facility