Troubleshooting Symptoms Charts C8.3 Industrial Page TS-58 Section TS - Troubleshooting Symptoms Lubricating Oil Pressure Low Cause Correction STEP 1 Engine angularity during operation exceeds specification ............. Refer to the Engine Data Sheet. OK Go To Next Step STEP 2 Lubricating oil does not meet specifications for ............. Change the oil and filters. Refer to Procedures 007-002 (Lubricating Oil and Filters) in Section 5 . operating conditions OK Go To Next Step Check for a missing dipstick, rain caps, or oil fill caps. Change the oil. Refer to the OEM service manual. STEP 3 Lubricating oil is diluted with water .............
OK Go To Next Step Make sure the correct lubricating oil is being used. Refer to Procedure 018-003 (Lubricating Oil Recommendations and Specifications) in Section V. STEP 4 Lubricating oil viscosity not correct ............. OK Go To Next Step STEP 5 Lubricating oil filter is plugged ............. Change the oil and filter. Refer to Procedure 007-002 (Lubricating Oil and Filters) in Section 5. OK Go To Next Step STEP 6 Lubricating oil is contaminated with coolant or fuel ............. Change the oil and filters. Refer to the Lubricating Oil Contaminated symptom tree. OK Go To Next Step STEP 7 Lubricating oil leak (external) ............. Inspect the engine for external oil leaks.
Tighten the capscrews, pipe plugs, and fittings. Replace gaskets, if necessary. Refer to OEM service manual. OK Go To Next Step STEP 8 Lubricating oil level is above or below specification ............. Check the oil level. Add or drain oil, if necessary. Refer to Procedure 007-043 (Lubricating Oil Level) in Section 3. OK Go To Next Step STEP 9 Lubricating oil pressure switch, gauge, or sensor is ............. Check the oil pressure switch, gauge, or sensor for correct operation and location. Refer to the OEM service manual. malfunctioning or is not in the correct location OK Go To Next Step