Cummins — 4021330

Maintenance Schedule C8.3 Industrial Page 2-4 Section 2 - Maintenance Guidelines 4 Follow the manufacturer's recommended maintenance procedures for the starter, alternator, generator, batteries, electrical components, engine brakes, exhaust brake, charge-air cooler, air compressor, refrigerant compressor, and fan clutch. 5 This cooling system requirement to Flush at this scheduled maintenance includes Drain, Flush, and Fill.

Marine Applications Maintenance Procedures at Daily Interval 1 ...................................................................................................Section 3 Fuel-Water Separator - Drain Lubricating Oil Level - Check Coolant Level - Check Sea Water Strainer - Clean Marine Gear - Check 1 Drive Belts - Check Maintenance Procedures at 75 Hours or 3 Months 3 .....................................................................................Section 4 Zinc Anode - Check 3 Cooling System Hoses - Check Sea Water Hoses - Check Air Cleaner Restriction - Check Batteries - Check Battery Cables and Connections - Check Component Connector and Pin Inspection - Check Maintenance Procedures at 300 Hours or 1 Year 1, 2 .....................................................................................Section 6 Fuel Filter (Spin-On Type) - Change Fuel-Water Separator Element - Replace Lubricating Oil and Filters - Change 2 Coolant Filter - Change Engine Coolant Heater - Check Marine Gear Oil Cooler - Flush 1 Supplemental Coolant Additive (SCA) and Antifreeze Concentration - Check 2 Heat Exchanger - Flush Sea Water Pump - Replace Aftercooler Assembly (Sea Water) - Flush Air Cleaner Assembly (Engine-Mounted) - Check Air Intake Piping - Check Marine Gear Oil - Check 1 Radiator Pressure Cap - Check Engine Wiring Harness - Check Maintenance Procedures at 600 Hours or 2 Years .......................................................................................Section 8 Vibration Damper, Rubber - Inspect for Reuse Vibration Damper, Viscous - Inspect for Reuse Overhead Set - Adjust Cooling System - Flush 4 Cooling Fan Belt Tensioner- Check 1 Consult the marine gear manufacturer operator's manual for specifications and recommendations.