MAN — MAN Series 50 Operator's Guide

DDEC IV SYSTEM When the Cruise Control switch is in the ON position, cruise control is engaged by momentarily contacting the “Set/Coast” switch to the ON position. Holding the switch in the ON position allows the vehicle to slow to a lower speed. Toggling the switch will result in a one mile-per-hour (1.6 kph) decrease in vehicle speed. If cruise control has been disabled, toggling the “Resume/Accel” switch restores the vehicle to the previously set cruise speed. LOSS OF VEHICLE CONTROL To avoid injury from loss of vehicle control, do not activate the Engine Brake system under the following conditions:

On wet or slippery pavement, unless the vehicle is equipped with ABS (anti-lock braking system) and you have had prior experience driving under these conditions. Using either the brake or the clutch will disable cruise control. When driving without a trailer (bobtailing) or pulling an empty trailer. Engine Brakes Engine brakes are enabled by an ON/OFF switch mounted on the dash. A separate intensity switch is used to select low, medium or high braking power. The engine brakes will only operate when the electronic foot pedal assembly (EFPA) is fully released. Disengaging the clutch will prevent the engine brakes from operating.

If the tractor drive wheels begin to lock or there is fishtail motion after the Engine Brake is activated, deactivate the brake system immediately if this occurs. Engine brakes will supply braking power even when in cruise control. The electronic control module (ECM) will control the amount of engine braking with respect to the cruise control set speed. The maximum amount of braking ( low, medium, high ) is selected with the dash switches. 26 All information subject to change without notice. (Rev. 01/04) DDC-SVC-MAN-0058 Copyright © 2004 DETROIT DIESEL CORPORATION