MAN — MAN Series 50 Operator's Guide

SERIES 50 OPERATOR'S GUIDE Engine Brakes and Cruise Control Shifting Depending on your transmission model, the gear split may vary from 500 to 300 rpm. The electronic governor provides almost no overrun capability; and, if the transmission is downshifted too early, you will experience a temporary loss of pulling power until the engine speed falls below rated speed. If your engine is equipped with both cruise control and engine brake retarders, the engine retarders can operate automatically while you are in cruise control.

If the cruise control/engine brake function is turned ON in the ECM (electronic control module) programming, the engine retarders will come on “low” when your set road speed increases a few miles-per-hour (kilometers per hour) above your cruise set speed. If your speed continues to increase, the ECM will increase the engine retarders' braking power progressively. When the vehicle returns to the set cruise speed, the engine retarders will “turn off” until you need them. In general, when using a 7- or 9-speed transmission, you should always downshift between 1250 and 1300 rpm. This is true even on steep grades with heavy loads.

When using an 18-, 15- or 13-speed transmission, you will need to downshift at an rpm that allows “less than rated” rpm before throttle application in the next gear down. You may want to limit engine speed to 1900 rpm in all gears. The Series 50 provides constant horsepower from 1800 rpm through 2100 rpm, but fuel economy is not as efficient above 1800 rpm. For safety reasons, don't use cruise control when it is not possible to keep the vehicle at constant speed due to: Winding roads Heavy traffic Slippery pavement Descending grades that call for engine brake assistance.

For an explanation of the engine brake retarder system and recommendations for proper operation, refer to section ENGINE BRAKE SYSTEM. All information subject to change without notice. (Rev. 01/04) 39 DDC-SVC-MAN-0058 Copyright © 2004 DETROIT DIESEL CORPORATION