ENGINE BRAKE SYSTEM After it is switched on, the engine brake system is automatically activated each time you remove your feet completely from the clutch pedal and throttle. NOTE: Some systems may be programmed to activate themselves only when the brake pedal is pressed, so read your vehicle owner's manual thoroughly to find out if you have this option. The engine brake automatically deactivates itself when you press the clutch pedal while shifting gears. NOTICE: Do not attempt to “double clutch” the transmission while the engine brake system is turned on. Shifting gears without depressing the clutch or using the engine brake to reduce engine rpm may result in serious powertrain damage.
LOSS OF VEHICLE CONTROL To avoid injury from loss of vehicle control, do not activate the Engine Brake system under the following conditions: Anti-Lock Braking Systems On wet or slippery pavement, unless the vehicle is equipped with ABS (anti-lock braking system) and you have had prior experience driving under these conditions. Vehicles equipped with ABS (anti-lock braking systems) have the ability to turn the engine brake retarder OFF if a wheel-slip condition is detected. The engine brake will automatically turn itself ON once the wheel slip is no longer detected.
The DDEC system will deactivate the engine brake system when the engine speed falls below 1000 rpm or when the vehicle slows down to a pre-set speed, depending on DDEC programming. This prevents stalling the engine. Engine brakes can also be used with vehicle cruise control TURNED ON. When driving without a trailer (bobtailing) or pulling an empty trailer. If the tractor drive wheels begin to lock or there is fishtail motion after the Engine Brake is activated, deactivate the brake system immediately if this occurs. 42 All information subject to change without notice. (Rev. 01/04) DDC-SVC-MAN-0058 Copyright © 2004 DETROIT DIESEL CORPORATION