SERIES 50 OPERATOR'S GUIDE Item 2 – Fuel and Fuel Tank (48,000 kilometers) or 300 hours for construction/industrial applications to drain off any water and/or sediment. Keep the fuel tank filled to reduce condensation. See Figure 12. PERSONAL INJURY To avoid injury from improper use of chemicals, follow the chemical manufacturer’s usage, handling, and disposal instructions. Observe all manufacturer’s cautions. Figure 12 Filled Fuel Tank Before adding fuel, refer to section How to Select Fuel Oil in the How To section of this guide. Every 120,000 miles (192,000 kilometers), 12 months, or 600 hours for construction/industrial applications tighten all fuel tank mountings and brackets.
At the same time, check the seal in the fuel tank cap, the breather hole in the cap and the condition of the flexible fuel lines. Repair or replace the parts, as necessary. Refill the tank at the end of each day's operation to prevent condensation from contaminating the fuel. Condensation formed in a partially filled tank promotes the growth of microorganisms that can clog fuel filters and restrict fuel flow. To prevent microbe growth, add a biocide to the fuel tank or primary fuel supply. Water accumulation can be controlled by using additives containing methyl carbitol or butyl cellusolve. Follow manufacturer's usage, handling and safety precautions.
Open the drain at the bottom of the fuel tank every 30,000 miles All information subject to change without notice. (Rev. 01/04) 65 DDC-SVC-MAN-0058 Copyright © 2004 DETROIT DIESEL CORPORATION