MAN — MAN Series 50 Operator's Guide

SERIES 50 OPERATOR'S GUIDE All hoses in and out of machinery should be replaced during major overhaul and/or after a maximum of five (5) years of service. required, but do not overfill. Before adding coolant, refer to section How to Select Coolant in this guide. Make a daily visual check for cooling system leaks. Look for an accumulation of coolant when the engine is running and when it is stopped. Coolant leaks may be more apparent on a engine when it is cold. NOTE: Fire-resistant fuel and lube oil hose assemblies do not require automatic replacement after five years of service or at major overhaul, but should be inspected carefully before being put back into service.

Coolant Inhibitors The inhibitors in antifreeze solutions must be replenished with a non-chromate corrosion inhibitor supplement when indicated by testing the coolant. In addition, the engine can be equipped with a coolant filter/inhibitor system as an installed option or as an after-sale item. Item 4 – Cooling System HOT COOLANT To avoid scalding from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Wear adequate protective clothing (face shield, rubber gloves, apron, and boots). Remove the cap slowly to relieve pressure. The cooling system must be full for proper operation of the engine.

Coolant Level — Check the coolant level daily and maintain it near the bottom of the filler neck on the radiator. On some installations this is done by checking an overflow bottle or sight glass. Add coolant as All information subject to change without notice. (Rev. 01/04) 67 DDC-SVC-MAN-0058 Copyright © 2004 DETROIT DIESEL CORPORATION