Ch 2 page 103 TRANSMISSION Clutch “C“ Disengage and remove both rectangular rings (1). Figure 267 Idler Pull the bearing inner ring from the shaft. (S) Grab sleeve 850317-00081 Figure 268 Remove the snap ring Figure 271. On the 4 assembly openings of the washer press the snap ring with a screwdriver flush into the annular groove of the shaft (see Figure 269) and pull off the idler by means of the 3-armed puller at the same time. Figure 269 Legend: 1 = Idler 2 = Shaft 3 = Axial bearing cpl. 4 = Washer 5 = Snap ring Figure 270 SHOP MANUAL