TRANSMISSION Ch 2 page 108 Clutch “D“ Disengage and remove both rectangular rings (1). Figure 285 Idler Pull the bearing inner ring off the shaft. (S) Grab sleeve 850317-00081 Figure 286 Remove the snap ring Figure 289. On the 4 assembly openings of the washer press the snap ring with a screwdriver flush into the annular groove of the shaft (see Figure 287) and pull off the idler by means of the 3-armed puller at the same time. Figure 287 Legend: 1 = Idler 2 = Shaft 3 = Axial bearing cpl. 4 = Washer 5 = Snap ring Figure 288 SHOP MANUAL