TRANSMISSION Ch 2 page 110 Remove the snap ring Figure 295. On the 4 assembly openings of the gear press the snap ring with a screwdriver flush into the annular groove of the shaft (see Figure 293) and pull off the gear by means of the 3-armed puller at the same time. Figure 293 Legend: 1 = Gear 2 = Shaft 3 = Snap ring Figure 294 Remove the gear (1) and disengage the snap ring (2). Figure 295 Press the shaft (1) out of the disc carrier under a hydraulic press. Pay attention to the released shaft (1)! Figure 296 SHOP MANUAL