Ch 2 page 127 TRANSMISSION Heat up the gear ring (1) (approx. 120° C) and mount it onto the disc carrier (2) until contact. Use safety gloves! Adjust the gear ring after cooling down! Figure 353 Assemble the washer (1) until contact is obtained and fasten it with the hexagon screws (2). Tightening torque (M8/10.9x20) M A = 34 Nm Figure 354 Heat up the teeth of the disc carrier (1) (approx. 120° C). Figure 355 Assemble the disc carrier (1) onto the shaft (2) until contact. Use safety gloves! Adjust the disk carrier after cooling down! Figure 356 SHOP MANUAL WARNING CAUTION WARNING CAUTION