TRANSMISSION Ch 2 page 130 Insert the washer (1) and the bearing outer ring (2) with grease into the idler. Figure 365 Align the inner clutch discs and assemble the idler (1) until contact is obtained. By means of short left-hand/right-hand rotations mount the inner clutch discs onto the inner dick carrier. Figure 366 Heat up the bearing inner ring of the taper roller bearing (approx. 120° C). Figure 367 Install the bearing inner ring (1) until contact. WARNING Use safety gloves! Adjust the bearing inner ring after cooling down! Install, align and grease the rectangular rings 42x2.5 (2). Figure 368 SHOP MANUAL CAUTION