Ch 2 page 135 TRANSMISSION Heat up the internal teeth of the gear (approx. 120° C). Figure 384 Assemble the gear (1) until the snap ring has engaged into the recess of the gear. NOTE Both ends of the snap ring must be located in one of the four mounting holes (see arrows) The snap ring must be engaged into both recesses of shaft and gear! CAUTION Use safety gloves! Figure 385 Heat up the bearing inner ring of the taper roller bearing (approx. 120° C). Figure 386 Assemble the bearing inner ring (1) until contact. WARNING Use safety gloves! Adjust the bearing inner ring after cooling down! Figure 387 SHOP MANUAL CAUTION