Ch 2 page 137 TRANSMISSION Use grease to fix the axial washer 80x105x1 (1) to washer(2). By means of a suitable pressure piece the washer (2) must be pressed until contact is obtained, i.e. until the snap ring has engaged into the recess of the washer. Figure 392 NOTE Both ends of the snap ring must be located in one of the four mounting holes (see arrows)! The snap ring must be engaged into both recesses of shaft and washer! Figure 393 Heat up the bearing inner ring of the taper roller bearing (approx. 120° C). Figure 394 Assemble the bearing inner ring (1) until contact. WARNING Use safety gloves! Adjust the bearing inner ring after cooling down! Figure 395 SHOP MANUAL CAUTION