TRANSMISSION Ch 2 page 142 Heat up the internal teeth of the gear (approx. 120° C). Figure 411 Assemble the gear (1) until the snap ring has engaged into the recess of the gear. NOTE Both ends of the snap ring must be located in one of the four mounting holes (see arrows)! The snap ring must be engaged into both recesses ofshaft and gear! Use safety gloves! Figure 412 Heat up the bearing inner ring of the taper roller bearing (approx. 120° C). Figure 413 Assemble the bearing inner ring (1) until contact. WARNING Use safety gloves! CAUTION Adjust the bearing inner ring after cooling down! Figure 414 SHOP MANUAL WARNING