TRANSMISSION Ch 2 page 146 Clutch “V“ Press the sliding bearing (1) into the shaft until contact and oil it. (S) Driver tool 850317-00086 Figure 427 Heat up the bearing inner ring of the taper roller bearing (approx. 120° C). Insert the shaft (1) into the locking device and assemble the bearing inner rings (2) until contact. Figure 428 Pay attention to the installation position! WARNING Use safety gloves! Adjust the bearing inner ring after cooling down! Assemble the spacer bush (3). (S) Locking device 850317-00083 Figure 429 Insert the bearing outer rings (1) with grease into the idler. Figure 430 SHOP MANUAL CAUTION