TRANSMISSION Ch 2 page 188 Mount O-rings 38x2 und 59x2 (1) onto the input shaft (3) and grease them. Snap ring SB 76 (2) has to be snapped into the groove. Figure 586 Assemble input shaft (1) with slip bushing until the snap ring has snapped into the recess of the input shaft (2) clutch “V”. Both ends of the snap ring must be placed in one of the four mounting holes – see Figure 588! (S) Slip bushing 850317-00088 Figure 587 Legend: 1 = Input shaft clutch “V” 2 = Input shaft 3 = Snap ring SB 76 (green) Figure 588 SHOP MANUAL Input shaft (1) is axially fixed! NOTE NOTE