TRANSMISSION Ch 2 page 218 Legend see Figure 700. 1 = Transmission housing 2 = Taper roller bearing 3 = Shaft seal 100x130x12 4 = Output shaft Figure 700 Press the screen sheet (1) onto the output flange (2). Figure 701 Assemble the output flange (1) until contact and insert the O-ring 69x3 (2) into the gap of output flange and shaft. Figure 702 Fasten the output flange (1) by means of washer (2) and hexagon screws (3). Prior to the reassembly oil the hexagon screws. Tightening torque (M12/10.9x65) MA = 120 Nm New hexagon screws have generally to be installed! Figure 703 SHOP MANUAL NOTE