TRANSMISSION Ch 2 page 260 Remove old sealant and clean flange surface of hydraulic pump. Same procedure on transmission flange end. Renew the O-ring (8) refer to parts catalogue Screw in and tighten screw (9) Allen wrench: 14mm Torque: 330Nm Figure 837 Fill front differential: (For fluid type, quantity and specifications, refer to the Hyundai Operating & Maintenance Manual Chapter 6) Hook chains into the 3 eyebolts on transmission. Adjust the chains to keep transmission in level. Carefully place transmission on the 3 mounting points. If shims were used on screws when disassembled, use the same shims when reassembling. Figure 838 Figure 839 SHOP MANUAL