TRANSMISSION Ch 2 page 266 Assemble the body heating assembly (if it was assembled on the machine) Assemble 4 screws on exhaust pipe clamps Figure 857 Assemble the body heating bracket. (4 screws) Figure 858 Assemble the clamp of the hinge bearing lubrication from the body heating bracket. Remember to bleed the system after transmission reassembly Bleeding emergency steering pump: Figure 859 Figure 860 SHOP MANUAL NOTE 1. Carefully open plug on emergency steering pump. 2. Close when system is purged of any air bubbles. 3. Start and run the engine, perform steps 1-2 again after engine is stopped.
CAUTION Remember to re-check the hydraulic level after turning ON the machine after the transmission replacement.