Ch 2 page 33 TRANSMISSION Disconnect the T/M power off / rear drive shaft joint (4 screws). Tie the rear drive shaft on the frame (near the hinge point) to keep it suspended Figure 16 Remove the transmission cover (8 screws) and the bottom guard (4 screws) When assembling, use Loctite™ 262 or Threebond medium 1374 on thread. Tightening torque ( 1 / 2 ” x 2 1 / 4 ” -10.9 UNF): 120 Nm. Figure 17 Figure 18 Disassemble the 2 final power drive shaft joints. Turn the wheels to reach the screws, if necessary. 4 screws RHS and LHS Figure 19 SHOP MANUAL