TRANSMISSION Ch 2 page 94 Clutch “B“ Disengage and remove both rectangular rings (1). Figure 235 Idler/Gear Pull the bearing inner ring off the shaft. (S) Grab sleeve 850317-00081 Figure 236 Remove the snap ring Figure 239 On the 4 assembly openings of the gear press the snap ring with a screwdriver flush into the annular groove of the shaft (see arrows Figure 237) and pull off the gear by means o the 3-armed puller at the same time. Figure 237 Legend: 1 = Idler 2 = Gear 3 = Shaft 4 = Snap ring Figure 238 SHOP MANUAL