Troubleshooting chart for GS II and EAS II shifting systems and notes on how to use it correctly 29.10.2003 TR Troubleshooting chart for GS II and EAS II shifting systems and notes on how to use it correctly 41 /41 If the ignition key is turned again straight away, a system check cannot be fully carried out. As a result a "CAN communication" fault code is set in the systems. There must be a guaranteed voltage supply of 24 V and, when starting up in particular, the voltage level should not fall below 20 volts. Especially when starting at temperatures below +5 °C, an adequate supply of compressed air is required to open the drive clutch.
Otherwise undervoltage, CAN communication and implausible speed sensor fault codes are set in the systems. The foot throttle actuator setting should be checked in case of doubt and readjusted if necessary. After "Ignition On" wait for the sound speaker to extinguish (automatic system check). 10/03 Trucks • Transmission Telligent automatic transmission in ACTROS and ATEGO > Specialist training Compressed air supply (8 bar) is very important for problem-free shifting. Shift speed and gear allocation can be insufficient if the settings are incorrect. 41