Komatsu — EVERY 500 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE Bleed the air as follows: REMARK Sometimes some air is still left inside water separator (3) after air bleeding, but the engine can be started by and it is your Total amount of grease PC200: 14.6 liters (3.86 US gal) PC220: 15.8 liters (4.17 US gal) 4. Install cover (2) with bolts (1). 4 - 59 16. Fill the fuel tank with fuel (to the position where the float 17. Loosen the knob of fe ed pump (7), pull it out, then pump it in and out until the movem REMARK It is not necessary to r emove the plug at the top of the fu el pre-filter and fuel main filter After the engine runs out of fuel, use the same procedure to operate feed pump (7) an 18.

After finishing to blee d air, push in the knob of feed pum p (7) and tighten it. es. 19. After replacing the filt er cartridge, start the engine and ru n it at low idling for 10 minut Check for leakage of tightening of the filter If there is still oil leak foreign material in the it. oil from the filter seal surface and tr anparent cap mounting. If any oil is leaking, check the cartridge. age, repeat Steps 1 - 7 to remove the filter cartridge, and if any damage or embedded packing surface is found, replace it with a new cartridge and rep eat Steps 8 - 19 to install operating feed pump (7) until its motion gets hard.

The rema ining air is naturally bled whe n the water separator is left as it is for some time CHECK SWING PINION GREASE LEVEL, ADD GREA Prepare a scale. 1. Remove bolts (1) (2 b olts) on the top of the revolving fram remove cover (2). 2. Insert scale (3) int o the grease through inspection adjustment hole (A). area passing the pinio if the level is low. Check if the grease Check that the height of grease (S) i n is at least 9 mm (0.355 in). Add gr is milky white. If it is milky white, ge the grease. Please contact 3. necessary to chan Komatsu distributor.