OG_PC5500-6_15045 PC5500-6 HYDRAULIC MINING SHOVELS

COVER

Operation & Maintenance Manual PC5500 -6 HYDRAULIC MINING SHOVEL SERIAL NUMBER 15045 and up This material is proprietary to Komatsu Mining Germany GmbH and is not to be reproduced, used, or disclosed except in accordance with written authorization from Komatsu Mining Germany GmbH. It is our policy to improve our products whenever it is possible and practical to do so. We reserve the right to make changes or add improvements at any time without incurring any obligation to insta ll such changes on products sold previously . Due to this continuos program of research and development, periodic revisions may be made to this publication.

It is recommended that customer contact their distributor for information on the latest revision. August 2006 Copyright 2006

Page 1

1. INTRODUCTION

1. INTRODUCTION 3

Page 3

1.1 CONTENTS OF THE BINDER

1.1 CONTENTS OF THE BINDER INTRODUCTION 1.1 CONTENTS OF THE BINDER Assembled in this file are the Operation-, Lubrication- and Mainte- nance Manuals for your KOMATSU Hydraulic Mining Shovel. 4

Page 4

1.2 DIVISION OF THE BINDER

INTRODUCTION 1.2 DIVISION OF THE BINDER 1.2 DIVISION OF THE BINDER Part 1: Operation Manual Part 2: Lubrication- and Maintenance Manual Part 3: Depending on the volume of Part 3 a second Binder "Volume 2" is being delivered with the Shovel. This Binder contains the General Assembly Procedure Manual for the Shovel, Specification Book- let, Service Literature for the Power Unit (Diesel Engine or Elec- tric Motor) and for Special Equipment. The Electrical- and Hydraulic Diagrams are attached in the pocket of the front cover. Refer to the "TABLE OF CONTENTS VOLUME 2 BINDER" for details. Read the Manuals before You Start the Engines.

Before operating the machine, familiarize yourself with its instru- ments and controls. Observe the instructions in these manuals for: your Personal SAFETY Operating SAFETY, and READY and EFFICIENT PERFORMANCE of your KOMATSU Hydraulic Mining Shovel. Periodic preventive inspections and maintenance are the surest means of keeping the machine in proper working order. Prompt detection and correction of minor irregularities, and immediate replacement of worn out or broken parts will prevent failures and avoid expenses. Replace damaged graphics and symbols. Observe safety precautions to prevent injury and damage.

If you have any questions concerning this literature please con- tact Komatsu Mining Germany GmbH Service Information Department 8151.40 P.O. Box 18 03 61 D - 40570 Dьsseldorf GERMANY 5

Page 5