Displaying Fault Codes (DFC) From SECM Memory To enter code display mode you must turn OFF the ignition key. Now turn ON the key but do not start the engine. As soon as you turn the key to the ON position you must cycle the Acceleration Pedal by depressing it to the floor and then fully releasing the pedal (pedal maneuver). You must fully cycle the Acceleration Pedal three (3) times within five (5) seconds to enable the display codes feature of the SECM. Simply turn the key OFF to exit display mode. The code list will continue to repeat until the key is turned OFF. An automatic code display feature is activated if a Acceleration Pedal fault condition exists.
This feature enables the service technician to view the fault codes by turning the key to the ON position, if a Acceleration Pedal malfunction is preventing the retrieval of the stored fault codes from the SECM. Clearing Fault (DFC) Codes To clear the stored fault codes from SECM memory you must complete the reset fault pedal maneuver. CAUTION Once the fault list is cleared it cannot be restored. First turn OFF the ignition key. Now turn ON the key but do not start the engine. As soon as you turn the key to the ON position you must cycle the Acceleration Pedal by depressing it to the floor and then fully releasing the pedal (pedal maneuver).
You must fully cycle the Acceleration Pedal ten (10) times within five (5) seconds to clear the fault code list of the SECM. Simply turn the key OFF to exit the reset mode. The code list is now clear and the SECM will begin storing new fault codes as they occur. Fault Action Descriptions Each fault detected by the SECM is stored in memory (FIFO) and has a specific action or result that takes place. Listed below are the descriptions of each fault action. Engine Shutdown: The most severe action is an Engine Shutdown. The MIL will light and the engine will immediately shutdown, stopping spark with the fuel lock-off closing. Delayed Engine Shutdown:
Some faults such as low oil pressure will cause the MIL to illuminate for 30 seconds and then shutdown the engine. Disable Throttle: The throttle moves to its default position. The engine will run at idle but will not accelerate. Limp Home Mode: A “limp home” mode reduces the lift truck power, and is provided to enable the operator to drive the lift truck in an unsafe situation but not use the truck for normal operation. MIL ONLY: The MIL will light by an active low signal provided by the SECM, indicating a fault condition but no further action will take place. Malfunction Indicator Light (MIL) = CODE 12 ON ON ON OFF OFF G420E/G424E Tier LP Engine Advanced Diagnostics 45