daewoo — Daewoo SB4136E00 Service Manual for G420E/G424E Tier LP Engine Lift Trucks

N2001 Removal Steps: 1. Close the liquid outlet valve in the fuel storage container. 2. Purge the system of fuel by starting the engine and running until all trapped fuel in the system is exhausted and the engine shuts down. 3. Remove the fuel inlet line (1) from the lock-off, the two vacuum lines (2) from the branch-tee fitting in the regulator vent and disconnect the lock-off connector (3). 4. Remove the two rear-mounting bolts that hold the regulator to the support bracket. This will allow you easier access to the remaining hose clamps. 5. Remove the two cooling lines (4) from the regulator. NOTE:

It will be necessary to either drain the coolant system or clamp off the coolant lines as close to the regulator as possible to avoid a coolant spill when these lines are disconnected. 6. Remove the fuel vapor outlet hose (5) from the regulator. 7. If it is necessary to fully disassemble the N2001 regulator, you will need to remove the fuel lock-off at this time. (1) Fuel inlet line (2) Vacuum line (3) Fuel Lock-off (4) Cooling line (5) Fuel vapor outlet hose NOTE For installation of the N2001 reverse the removal steps. 1 3 2 4 5 Figure 24 G420E/G424E Tier LP Engine N2001 Regulator/Converter 66