5. Turn the regulator body over with the rear fuel inlet plate facing up. Remove the primary valve access plug (7), the primary valve (8) and the primary valve o-ring seal (9). The primary valve goes through the inlet plate, then through the body assembly and is retained by the primary diaphragm (Figure R9). 6. Remove the body gasket (10), body o-ring seal (11) and the fuel inlet plate, exposing the fuel inlet expansion chamber and the coolant passage. NOTE For re-assembly of the N2001 regulator/converter, reverse the steps for disassembly. Tighten all fasteners to recommended torque values and test the regulator before installing in the vehicle.
Torque primary cover screws to (40-50 inch lbs.), secondary cover screws to (15- 18 inch lbs.). 3 10 11 Figure R7 Figure R8 8 9 Figure R8 Figure R9 G420E/G424E Tier LP Engine N2001 Regulator/Converter 68