4. Replace the air-valve sealing ring as shown (Figure M7). The ring is similar to a piston ring and forms a seal from the air valve assembly to the mixer main body. Small raised circular formations can be found on one side of this ring. Place the ring so that these circular markings face upward toward the fuel-metering pin for proper sealing. 5. Insert the air valve assembly into the main body (Figure M8). 6. Next, install the air valve spring (Figure M9). 7. After the air valve spring install the check valve plate (Figure M10). 8. Place the mixer to throttle body gasket over the check valve plate (Figure M11).
To properly install the gasket the hole for the idle port in the throttle adapter must be aligned with the idle port in the gasket. 9. Align the check valve notch in the throttle adapter with the mixer check valve and the adapter idle port with the mixer idle port. Install the throttle adapter tamper-resistant screws to the mixer (Figure M12). Figure M7 Figure M10 Figure M11 Figure M8 Figure M12 Figure M9 G420E/G424E Tier LP Engine N-CA55-500TR Mixer 73