Installing the Mixer/Throttle Assembly (1) GASKET-INTAKE MANIFOLD (2) ADAPTER-INTAKE MANIFOLD (3) BOLT-ADAPTER (4) BRACKET-TMAP (5) BOLT-TMAP BRACKET (6) TMAP SENSOR (7) WASHER-TMAP MTG (8) BOLT-TMAP MTG (9) GASKET-ITB(32MM) (10) ITB(32MM) (11) O-RING (12) APOLLO ADAPTER-ITB (13) FITTING (14) PLUG (15) BOLT-APOLLO ADAPTER (16) WASHER-ITB (17) BOLT-ITB (18) MIXER(CA55) (19) FITTING (20) AIR HORN ADAPTER, (21) WASHER-AIR HORN (22) BOLT-AIR HORN, (23) FITTING-VENTILATION (24) O-RING SPACER The mixer/throttle assembly consists of a manifold adapter, electronic throttle, mixer-throttle adapter and air horn adapter.
The manifold adapter is designed to mount the mixer/throttle assembly to a two-bolt intake manifold. The air horn adapter allows the intake hose from the air cleaner to be attached to the mixer air intake, along with the vent line from the engine PCV valve. 1. Align the Mixer-Throttle Adapter gasket between the mixer and the throttle adapter (Figure M15), and then attach the mixer to the adapter using the four tamper-resistant retaining screws. CAUTION The mixer must be installed with the idle port aligned with the idle port in the adapter, and the mixer check valve aligned with the valve recess in the adapter to operate properly (Figure M16). 2.
Tighten the four tamper-proof retaining screws to the specified torque (Figure M17). 22 (2.2 N•m) 21 23 20 19 Figure M15 13 18 (2.2 N•m) 15 12 (8.6 N•m) 17 14 16 11 24 4 10 7 6 3 (41.6 N•m) (4.2 N•m) 8 9 2 IDLE PORT CHECK VALVE 1 Figure M16 5 (0.8 N•m) INTAKE MANIFOLD Figure M17 G420E/G424E Tier LP Engine Test And Adjustments 75