BAIC U5 PLUS series — 1 (80)(1)

Inspection of washer nozzle If there is debris near the washer nozzle, please clean it up in time, otherwise it may affect the normal operation of the windshield washer. Inspection and cleaning of windshield wiper blades soft cloth; 5. After cleaning, gently put the wiper arm back in place. Contamination of either the windshield or the wiper blades will reduce the wiping effectiveness of wiper. The main pollution sources are dust, sediment, insect, sap and water waxes used in car washers. If the wiper sheet does not scrape well, use a quality cleaner or mild detergent to clean the windscreen and wiper sheet, and then rinse it off completely with clean water.

Put keyless start/stop button in "RUN" mode, toggle the combination switch of wiper and washer to spray water to the front and rear washer and observe the water spray pressure and spray position. If the water spray pressure is too low or the spray position is incorrect, please go to BAIC Motor Dealership for repairs. Maintenance and servicing The procedure to clean the wiper blades are as follows: 1. Lift the wiper arm away from the windshield. Pad the lower part of the wiper arm with a thick towel to prevent the wiper arm from accidentally bouncing back and damaging the windshield; 2. Lift the wiper arm away from the windshield; 3. Grasp the wiper arm; 4.

Carefully wipe the dust and dirt on the wiper blade and the surface of the windshield with a 159 Special windshield washer fluid shall be added in time to avoid dry wiping without liquid, otherwise the wiper blade will be damaged and the windshield will be easily scratched. The wiper blade must remain in good condition to obtain a clear field of view. When the ambient temperature is lower than 0 ℃, the washer fluid with corresponding antifreeze ability shall be used. To prevent schlieren from forming, wiper blades should be cleaned regularly with windshield cleaning agent. If the wiper blades are very dirty, then scrub them with a sponge or a cloth.

Do not allow dirt to enter the washer fluid, otherwise the washer nozzle may be blocked or damaged. In the case of cold weather, check whether the wiper blades are frozen every time before turning on the windshield washer. Open the washer only when the wiper blades are not obstructed.