BAIC U5 PLUS series — 1 (92)(1)

Bulb type Turn signals, brake lights, and headlamp are related to driving safety. Before driving the vehicle, check whether the vehicle light is in good condition. Bulb specification Jump start If the vehicle engine cannot be started due to over-discharge of the battery, the battery of other vehicles can be used to start the engine via jumper cable, meanwhile the following points shall be noted: Usually, other related parts need to be removed when replacing the bulb. Some bulbs need to be replaced from the engine compartment. This situation is complicated and requires professional skills and tools. It is recommended to go to the BAIC Motor Dealership to replace the bulb.

● The rated voltage of the power supply battery must be above 12 V, and its capacity (Ah) must not be lower than the fault battery. Emergency handling ● Use only jumper cable with a sufficiently large cross-section. ● Use only jumper cable with insulated electrode clamps.

183 Reversing lamp LED 1 White Rear fog lamp LED 1 Red High-mount ed stop lamp LED 1 Red License plate lamp W5W 2 White Indoor front ceiling lamp C10W 1 Yello w Trunk lamp W5W 1 White Side turn signal lamp LED One for left and one for right respective ly Yello w Lamp name Type Quantity Light color Front position lamp LED One for left and one for right respective ly White Daytime running lamp LED One for left and one for right respective ly White Front turn signal lamp PY21 W One for left and one for right respective ly Amb er Low beam H7 One for left and one for right respective ly White LED High beam H1 One for left and one for right respective ly White LED Rear position lamp LED One for left and one for right respective ly Red Braking lamp LED One for left and one for right respective ly Red Rear turn signal lamp LED One for left and one for right respective ly Amb er LED lights can not be replaced alone, it is recommended to go to the BAIC Motor Dealership for inspection and replacement.

The bulb may be very hot when it goes out, so wait the bulb for cooling before replacing it. At jump start, the two vehicles must not touch each other. Otherwise, once the positive poles of the two battery are connected, the current will be connected immediately, which will cause danger. Do not touch the bulb directly by hand, use no fluff cloth wrapped, so as not to affect the lighting effect.