BAIC U5 PLUS series — 1 (31)

Close the engine compartment hood. Trunk Trunk precautions 1. Check and ensure that there is no other foreign matter in the engine compartment to prevent damage to the vehicle parts. Operating system and equipment 2. Hold the engine hood steady and push it upward slightly so that the strut can come out of the support hole. Retract the strut and fasten it. 3. Open the engine hood to the proper position, pinch the rubber sleeve of the strut, pull the strut out of the clip, and insert its head into the oval hole on the engine hood to confirm it is supported reliably. 3.

Slowly lower the engine compartment cover to a position about 20cm away from the upper part of the front grille, release both hands, and use the gravity of the engine compartment cover to lock up. After lock up, push and pull the engine compartment cover up and down to confirm that the safety lock up is in place. 62 If there is steam or smoke coming out from the engine compartment, do not open the engine hood to prevent injuries. Keep the trunk lid closed during driving. If the trunk cover is open, the luggage in the trunk may be accidentally thrown out during driving, resulting in an accident or damage. So make sure the trunk lid is closed before driving.

If the engine compartment lid is not locked up when the vehicle is driving, the engine compartment lid may be opened by high-speed airflow, causing serious accidents. Therefore, it is necessary to check whether the locking device has locked reliably after closing the engine compartment lid. Passengers are strictly prohibited to be carried in the trunk, otherwise serious injury or even death may be easily caused in case of emergency braking or collision. If you lower the engine compartment too far from the upper part of the front grille and then let go or close the engine compartment down hard, you may damage the headlamp and front grille. Do not allow children to enter the trunk.

If children are accidentally locked in the trunk, it may cause death due to overheating or suffocation. If the hood cannot be closed due to low temperature, turn the rubber buffer in the engine compartment slightly clockwise until it can be closed.