Group 28 Troubleshooting MID 130 PPID 11 Gear Selector Cylinder 2, Position 72 Type of fault: FMI Description: Fault Condition: Possible Symptoms: Possible Cause:
FMI 3 • Voltage above normal or shorted high • Status from ASIC is short circuit to U-BATT • Yellow lamp is sent • Slow gear changes • N/A FMI 5 • Current below normal or open circuit • Status from ASIC is open circuit • Yellow lamp is sent • Slow gear changes • N/A FMI 6 • Current above normal or grounded circuit • Status from ASIC is short circuit to ground • Yellow lamp is sent • Slow gear changes • N/A FMI 13 • Calibration value out of range • The checksum in NVRAM is not correct or • The sensor has not been calibrated • Yellow lamp is sent • Cranking is inhibited • Engine cannot start • N/A