AT Commands User Manual 83 17.4 Quality of service profile (requested) +CGQREQ Command syntax Description AT+CGQREQ= , , ,reliability>, , This command allows the TE to specify a quality of service profile that is used when the MT sends an activate PDP context request message to the network. The set command specifies a profile for the context identified by the (local context identification parameter). The syntax form used only with parameter , causes the requested profile for the indicated context number to become undefined. AT+CGDCONT is needed previously AT+CGQREQ=1,1,1,1,1,1 OK or CME ERROR: Read command AT+CGQREQ? +CGQREQ: 1,1,1,1,1,1 i.e. +CGQREQ: , , , , , +CGQREQ: , , , , , ...
OK Test command AT+CGQREQ=? +CGQREQ: “IP”, (0-3), (0-4), (0-5), (0-9), (0-18,31) i.e. +CGQREQ: , (list of supported s), (list of _ supported s), (list of supported s), (list of supported s), (list of supported s) +CGQREQ: ,(list of supported s), _ (list of supported s) , (list of supported s), (list of supported s), (list of supported s)... OK 17.5 Quality of service profile (minimum acceptable) +CGQMIN Command syntax Description AT+CGQMIN= , , , , , This command allows the TE to specify a QoS (Quality of Service) minimum acceptable profile which is checked by the MT against the negotiated profile returned in the activate PDP context accept message.
The profile is identified by the parameter. AT+CGDCONT is needed previously AT+CGQMIN=1,1,1,1,1,1 OK or CME ERROR: Read command AT+CGQMIN? +CGQMIN: , , , , , OK Test command AT+CGQMIN=? +CGQMIN: “IP”,(0-3),(0-4),(0-5),(0-9),(0-18,31) i.e. +CGQMIN: , (list of supported s), (list of supported s), (list of supported s), (list of supported s), (list of supported s) [+CGQMIN: , (list of supported s), (list of supported s), (list of supported s), (list of supported s), (list of supported s)... OK