Group 10 Blower Housing and Flywheel FLYWHEEL SCREEN ADJUSTMENT Adjust gap (C) between the blades under screen (A) and blower housing (B) to specifications using spacers. SPECIFICATIONS M38037 -UN-29AUG88 Gap . . . . . . . . . . . . . . . . . . . . . . . . . . 1—3 mm (0.039—0.118 in.) MX,2110A1,A2 -19-21OCT92 CTM5 (20OCT92) 21-10-1 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=112 REMOVE AND INSTALL BLOWER HOUSING 1. Remove recoil starter. 2. Remove air cleaner assembly. -UN-11MAR91 3. Remove dipstick tube (A). 4. Remove nut and washer (B), starter cup/screen assembly (C) and spacer(s). M80315 5. Remove blower housing (D). 6. Install blower housing. A—Dipstick Tube 7.
Install spacer(s) and starter cup/screen assembly. B—Nut and Washer C—Starter Cup/Screen D—Blower Housing 8. Adjust flywheel screen. (See this group.) NOTE: Install washer with concave side toward flywheel. 9. Install washer and nut. Tighten nut to 60 N·m (44 lb-ft). 10. Install dipstick tube. 11. Install air cleaner assembly. 12. Install recoil starter. MX,2110A1,A1 -19-21OCT92 21 10 1