Cylinder Block, Valves and Internal Components/Piston and Connecting Rod DISASSEMBLE, INSPECT AND ASSEMBLE PISTON AND CONNECTING ROD 1. Remove circlip, piston pin (B) and connecting rod (A). 2. Inspect all parts for wear or damage. Replace as necessary. (See procedures in this group.) M80325 -UN-11MAR91 3. Apply a light film of oil to piston pin and connecting rod bearing. MX,2120A1,A14 -19-21OCT92 CTM5 (20OCT92) 21-20-9 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=124 8. Deglaze cylinder bore. (See Section 100, Group 15.) 9. Align piston assembly to cylinder bore with piston ring end gaps as shown. 10. Apply a light film of oil to piston and rings.
Compress -UN-19MAR91 rings with a ring compressor. 11. Apply a light film of oil to cylinder bore, connecting rod bearing surface and cap screws. M80324 12. Install piston assembly in cylinder bore with notch on piston head facing flywheel side. 13. Install connecting rod cap and lock plate. Tighten A—First Ring End Gap cap screws to specifications. B—Second Ring End Gap C—Oil Ring End Gap D—Flywheel Side 14. Bend locking tabs over cap screws. E—45˚ Angle F—Notch 15. Install camshaft. G—Upper Side Rail End Gap H—Lower Side Rail End Gap 16. Install cylinder head. TORQUE SPECIFICATIONS Connecting Rod Cap Screws . . . . . . . . . . . . . . . 19 N·m (168 lb-in.) MX,2120A1,A13 -19-21OCT92 21 20 9