Cylinder Block, Valves and Internal Components/Inspect and Replace INSPECT AND REPLACE GOVERNOR IMPORTANT: Removal damages governor. If not damaged, do not remove. 1. Remove crankcase cover. (See this group.) M51762 -UN-07SEP88 2. Inspect governor. If necessary to replace, remove with screwdriver. 3. If removed, press shaft (C) back into block until it protrudes 32.2—32.8 mm (1.267—1.291 in.). NOTE: Assemble sleeve and gear before installing assembly on shaft. 4. Install sleeve (A) into governor gear (B). 5. Install governor assembly onto shaft. Push down on assembly until it snaps into place.
MX,2120A1,A32 -19-21OCT92 CTM5 (20OCT92) 21-20-19 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=134 INSPECT AND REPLACE OIL SLINGER 1. Remove crankcase cover. (See this group.) 2. Remove cap screw and washer (A). -UN-11MAR91 3. Remove oil slinger (B). 4. Inspect for wear or damage. Replace if necessary. 5. Install oil slinger, washer and cap screw. M80337 6. Install crankcase cover. MX,2120A1,A31 -19-21OCT92 21 20 19