Group 25 Ignition and Charging System ADJUST ARMATURE AIR GAP 1. Turn flywheel magnet away from armature. 2. Insert feeler gauge blade (A) between flywheel and armature. M80340 -UN-11MAR91 3. Push armature against flywheel and tighten screws (B). 4. Turn flywheel to remove feeler gauge. AIR GAP SPECIFICATIONS Feeler Gauge Blade . . . . . . . . . . . . . . . . . . . . 0.30 mm (0.012 in.) MX,2125A1,A2 -19-21OCT92 REPLACE IGNITOR 1. Disconnect wiring lead (A). 2. Remove ignitor. M80341 -UN-11MAR91 NOTE: When installing ignitor, put wiring lead (B) under screw and washer. 3. Install ignitor. 4. Connect wiring lead.
CTM5 (20OCT92) 21-25-1 K Series Air Cooled Engine MX,2125A1,A3 -19-21OCT92 AllTractorManuals.com 220596 PN=136 REMOVE AND INSTALL ARMATURE WITH COIL 1. Remove blower housing. (See Group 10.) 2. Disconnect wiring lead (C). -UN-11MAR91 3. Remove cap screws (A) and armature with coil (B). 4. Loosely install armature with coil. M80339 5. Connect wiring lead. 6. Adjust armature air gap. (See this group.) 7. Install blower housing. MX,2125A1,A1 -19-21OCT92 21 25 1