John Deere K Series Air-Cooled Engines — REMOVE AND INSTALL CYLINDER HEAD

Cylinder Head/Cylinder Head CTM5 (20OCT92) 25-15-2 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=155 REMOVE AND INSTALL CYLINDER HEAD 1. Disconnect spark plug wiring lead. 2. Remove fuel tank. (See Group 05.) -UN-02APR91 3. Remove brackets (B). 4. Remove shield (A). 5. Remove spark plug. M80352 6. Remove cylinder head and gasket. 7. Make repairs as necessary. (See procedures in this group.) IMPORTANT: Gasket surfaces are coated with sealant. Do not damage surfaces or -UN-02APR91 gasket during installation. 8. Install cylinder head with new gasket. Install cap screws and tighten finger tight. M80353 9. Tighten cap screws in sequence shown.

Tighten to initial torque specifications. 10. Continue in sequence, 4 N·m (35 lb-in.) at a time, until final torque is as specified. 11. Install spark plug and tighten to specification. 12. Install heat shield. 13. Install fuel tank brackets. 14. Install fuel tank. TORQUE SPECIFICATIONS Initial Torque . . . . . . . . . . . . . . . . . . . . . . . . . . 10 N·m (89 lb-in.) Final Torque . . . . . . . . . . . . . . . . . . . . . . . . . . . 24 N·m (212 lb-in.) Spark Plug . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 N·m (20 lb-ft) MX,2515A1,A1 -19-21OCT92 25 15 2