John Deere K Series Air-Cooled Engines — INSPECT CAMSHAFT BALL BEARING—FG150G

Cylinder Block, Valves and Internal Components/Camshaft INSPECT CAMSHAFT BALL BEARING—FG150G 1. Remove PTO end oil seal. (See Inspect Oil Seals in this group.) 2. Remove camshaft bearing from crankcase cover using a bearing, bushing and seal driver set. M38073 -UN-29AUG88 3. Thoroughly clean bearing in solvent. Dip bearing in light weight oil. 4. Spin the bearing by hand and check for axial (A) and radial (B) free play. 5. Replace bearing if it is noisy or has too much play. 6. Install bearing flush to inside of crankcase cover using a bearing, bushing and seal driver set. 7. Install oil seal.

CTM5 (20OCT92) 25-20-8 K Series Air Cooled Engine MX,2520A1,A13 -19-21OCT92 AllTractorManuals.com 220596 PN=165 INSPECT CAMSHAFT PLAIN BEARINGS NOTE: FG150G crankcase cover is equipped with a ball bearing. 1. Remove camshaft. (See this group.) -UN-02APR91 2. Measure camshaft bearings in cylinder block and crankcase cover, if equipped. Replace block or cover if diameter is greater than specification. M80367 3. Install camshaft. Cylinder Block SPECIFICATIONS (MAX) Cylinder Block Crankcase Cover Bearing Bearing FG150G 15.04 mm — (0.592 in.) FG150D 15.04 mm 15.04 mm (0.592 in.) (0.592 in.) MX,2520A1,A12 -19-21OCT92 25 20 8