Fuel and Air Systems/Service IMPORTANT: To remove float, use a long nosed pliers on end of pin. Do not strike opposite end of pin. Damage to pin holder may result. IMPORTANT: Rinse carburetor body in warm water to neutralize corrosive action of cleaner on aluminum. 3. Rinse carburetor with warm water and dry with compressed air. Do not use rags or paper to dry parts: lint may plug holes or passages. Do not clean holes or passages with small drill bits or wire. 1. Soak carburetor body and all parts, except gaskets, float and plastic rings, in carburetor cleaning solvent for 1/2 hour maximum. 4. Inspect all parts for wear or damage, replace as necessary. NOTE:
Main jet high altitude kits are available. 2. Spray all passages with a carburetor cleaning spray to verify that all internal passages are open. Float is plastic. The float cannot be adjusted. Replace if necessary. MX,3005A1,A4 -19-21OCT92 CTM5 (20OCT92) 30-05-3 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=192 SERVICE BREATHER NOTE: Breather is located in cylinder head. 1. Remove engine cover. (See Group 10.) -UN-07SEP88 2. Remove breather cover and gasket. 3. Remove rocker arm cover. 4. Measure air gap between reed valve (A) and valve M51757 seat (B) at valve tip. Replace reed valve if gap exceeds specification. 5. Remove breather valve (C). 6.
Inspect breather for sticking, binding, cracks or distortion. Replace breather if worn or damaged. -UN-07SEP88 7. Inspect valve seating surface. Surface must be free of nicks or burrs. 8. Check that drain back hole (D) in breather chamber is open. M51755 9. Install breather assembly, gasket and cover. SPECIFICATIONS A—Reed Valve B—Valve Seat Air Gap (MAX) . . . . . . . . . . . . . . . . . . . . . . . . 0.20 mm (0.008 in.) C—Breather Valve (2 used) D—Drain Back Hole MX,3005A1,A5 -19-21OCT92 30 05 3