Cylinder Head and Valves/Rocker Arm Assembly CTM5 (20OCT92) 30-15-2 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=199 REMOVE, INSPECT AND INSTALL ROCKER ARM ASSEMBLY 1. Remove rocker arm cover. 2. Turn crankshaft until piston is at highest position in -UN-07SEP88 compression stroke. 3. Remove nut (C) and pivot (D) to remove arm (A). IMPORTANT: Mark push rods for reassembly in M51747 original locations. 4. Remove push rods (B). 5. Bend open lock tabs (E). Remove rocker arm studs and support plate. 6. Inspect parts for wear or damage. Replace as -UN-31AUG88 necessary. 7. Inspect push rods for bends using V-blocks and a dial indicator.
Turn rod slowly and read variation on indicator. Replace if variation is greater than specifications. M50044 8. Install support plate and studs. Tighten studs to specifications. Bend over lock tabs. A—Rocker Arm (2 used) IMPORTANT: Align rocker arms over push rods B—Push Rods during assembly. C—Nut (2 used) D—Pivot (2 used) 9. Install push rods, rocker arms, pivots and nuts. E—Lock Tab 10. Check valve clearance. (See this group.) 11. Install rocker arm cover. SPECIFICATIONS Push Rod Bend (Max) . . . . . . . . . . . . . . . . . . . 0.30 mm (0.012 in.) Rocker Arm Stud Torque . . . . . . . . . . . . . . . . . . . 7 N·m (62 lb-in.) MX,3015A1,A1 -19-21OCT92 30 15 2