Cylinder Block and Internal Components/Camshaft INSPECT CAMSHAFT Inspect camshaft for worn or broken teeth. NOTE: Camshaft and tappets are a matched set. Replace both camshaft and tappets if necessary. M80172 -UN-11FEB91 Measure PTO side journal (A), flywheel side journal (B), and lobes (C). Replace camshaft and tappets if less than specifications. SPECIFICATIONS (MIN) PTO Side Flywheel Side Cam Lobes Journal Journal 13.92 mm 13.92 mm 22.80 mm (0.548 in.) (0.548 in.) (0.898 in.) MX,3020A1,A3 -19-21OCT92 CTM5 (20OCT92) 30-20-3 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=208 INSPECT CAMSHAFT PLAIN BEARINGS 1. Remove camshaft. (See this group.) 2.
Measure camshaft bearings in cylinder block and crankcase cover. Replace block or cover if diameter is -UN-11FEB91 greater than specification. 3. Install camshaft. SPECIFICATIONS (MIN) M80173 Cylinder Block Crankcase Cover Cylinder Block Bearing Bearing 14.07 mm 14.07 mm (0.554 in.) (0.554 in.) -UN-11FEB91 M80174 Crankcase Cover MX,3020A1,A4 -19-21OCT92 30 20 3