Cylinder Block, Valves and Internal Components/Inspect and Replace INSPECT AND REPLACE GOVERNOR 1. Remove crankcase cover. (See this group.) 2. Remove sleeve (A). 3. Inspect bearing surfaces inside sleeve and on camshaft (B) for damage or wear. Replace parts as necessary. M51523 -UN-31AUG88 4. Check that weights (C) move freely. Replace entire weight assembly plate (D) if damaged. 5. Install plate (D), if removed, and governor sleeve. Align lower flange of governor sleeve with locator pin (E) A—Governor Sleeve B—Camshaft and insert into notches in weights. C—Weights D—Weight Assembly Plate 6. Install crankcase cover.
E—Locator Pin MX,3520A1,A39 -19-21OCT92 CTM5 (20OCT92) 35-20-23 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=268 INSPECT AND REPLACE GOVERNOR SHAFT NOTE: It is not necessary to remove governor shaft unless damaged. -UN-31AUG88 1. Remove crankcase cover. (See this group.) 2. Inspect shaft (A). Replace if damaged. 3. To replace shaft, loosen cap screw (B) on lever (C). M51522 4. Remove screws (D), clevis (E) and shaft. 5. Install shaft, clevis and screws. A—Governor Shaft B—Cap Screw 6. Tighten cap screw on governor lever. C—Governor Lever D—Screws E—Clevis 7. Install crankcase cover. MX,3520A1,A40 -19-21OCT92 35 20 23